Stihl RMI 632 P User Manual

EN
79
0478 131 8354 D - EN
Message:
1100 – Control panel
Control panel removed during travelling
Possible cause:
– Control panel has been removed during
automatic operation
Remedy:
– Confirm the message with OK –
automatic operation resumes once the
control panel has been inserted
Message:
1120 – Hood blocked
Check hood
then press OK
Possible cause:
– Permanent collision detected
– Uneven areas around or underneath
docking station floor plate
Remedy:
– Free robotic mower, remove obstacle or
change routing of perimeter wire if
necessary – then confirm message with
OK
– Check movement of hood and confirm
message with OK
– Level out uneven areas and confirm
message with OK (Ö 9.1)
Message:
1125 – Remove obstacle
Check wire routing
Possible cause:
– Perimeter wire routed inaccurately
Remedy:
– Check routing of the perimeter wire,
check clearances using the
iMOW® Ruler (Ö 12.5)
Message:
1130 – Stuck
Free iMOW®
then press OK
Possible cause:
– Robotic mower has become stuck
– Drive wheels are spinning
Remedy:
– Free robotic mower, level out mowing
area or change routing of perimeter
wire if necessary – then confirm
message with OK
– Clean drive wheels, if necessary
prevent operation during rain – then
confirm message with OK (Ö 11.11)
Message:
1135 – Outside
Place the iMOW® on the mowing area
Possible cause:
– Robotic mower is located outside
mowing area
Remedy:
– Return robotic mower to mowing area
Message:
1140 – Too steep
Check wire routing
Possible cause:
– Tilt sensor has detected slope
inclination exceeding 22°
Remedy:
– Change routing of perimeter wire, block
off lawns with slope inclinations
exceeding 22°
Message:
1160 – Handle actuated
Press OK to release
Possible cause:
– The robotic mower has been lifted by
carrying handle
Remedy:
– Confirm the message with OK
Message:
1170 – No signal
Switch on docking station
Possible cause:
– Docking station is switched off
– No reception of wire signal during
operation
– Robotic mower is located outside
mowing area
– Docking station or electronic
components were replaced
Remedy:
– Switch on docking station and give
mowing command
– Check power supply to docking station
– Check LED on docking station – the red
LED must be permanently illuminated
during operation (Ö 13.1)
– Return robotic mower to mowing area
– Link robotic mower and docking station
(Ö 11.15)
Message:
1180 – Dock iMOW®
Automatic docking
not possible
Possible cause:
– The docking station was not found

Stihl RMI 632 P Specifications

General

Brand	Stihl
Model	RMI 632 P
Category	Lawn Mower
Language	English