Stihl RMI 632 P - Docking Station Controls; Docking Station LED and Button

EN
61
0478 131 8354 D - EN
Insert loose, unstripped wire ends (1) to
the stop in the wire connector (2). Press
the wire connector together using suitable
pliers – ensure correct engagement.
Attach the perimeter wire strain relief to the
ground with two fixing pins as illustrated.
13.1 Docking station controls
A circular red LED (1) provides information
on the status of the docking station and the
wire signal.
Function button (2):
– Switching docking station on and off
– Activating Homecall
– Activating find wire break
LED does not illuminate:
– Docking station and wire signal are
switched off.
LED illuminates continuously:
– Docking station and wire signal are
switched on.
– Robotic mower is not docked.
LED flashes slowly (2 seconds on –
briefly off):
– Robotic mower is docked, battery is
charging if required.
– Docking station and wire signal are
switched on.
LED flashes rapidly:
– Perimeter wire is interrupted – wire
break or wire is not correctly connected
to the docking station.(Ö 16.7)
LED illuminates for 3 seconds, followed
by 1 second pause:
– Homecall was activated.
LED gives 3 short flashes, 3 long
flashes, 3 short flashes, followed by
approx. 5 second pause (SOS signal):
– Error in the docking station.
Switching the docking station on
and off:
The docking station is switched on
and off automatically during automatic
operation.
If the robotic mower is not docked, briefly
pressing the button activates the docking
station. The wire signal remains active for
48 hours if the robotic mower has not
previously docked.
Pressing the button for 2 seconds
switches off the docking station.
Activating Homecall:
Briefly press the button twice within
2 seconds during a mowing
operation.
The robotic mower ends the running
mowing operation, searches for the
perimeter wire and returns to the docking
station to recharge the battery. No further
mowing operation takes place in the
current active time.
13. Docking station
Homecall remains active until the
robotic mower is docked. Homecall
can also be ended by pressing the
button on the docking station twice
again.