Stihl RMI 632 P User Manual

EN
81
0478 131 8354 D - EN
Message:
2032 – Battery temperature
Outside temperature range
Possible cause:
– Temperature in battery during charging
too low or too high
Remedy:
– Allow robotic mower to warm up or cool
it down – observe permissible
temperature range of battery
Message:
2040 – Battery temperature
Outside temperature range
Possible cause:
– Temperature in battery when starting
mowing operation too low or too high
Remedy:
– Allow robotic mower to warm up or cool
it down – observe permissible
temperature range of battery (Ö 6.4)
Message:
2050 – Adapt mowing plan
Extend active times
Possible cause:
– Active times have been
shortened/deleted or the mowing
duration has been extended – the
stored active times are insufficient for
the necessary mowing operations.
Remedy:
– Extend the active times (Ö 11.7) or
shorten the mowing duration (Ö 11.7)
Message:
2060 – Mowing completed
Press OK to release
Possible cause:
– Mowing in secondary area successfully
completed
Remedy:
– Return robotic mower to mowing area
and dock to charge battery (Ö 15.7)
Message:
2070 – GPS signal
No reception at edge
Possible cause:
– The entire edge of the mowing area is in
a dead spot
Remedy:
– Repeat edge following (Ö 11.13)
– Contact a STIHL specialist dealer for a
detailed diagnosis
Message:
2071 – GPS signal
No reception at starting pt. 1
Possible cause:
– Starting point 1 is in a dead spot
Remedy:
– Change the position of starting point 1
(Ö 11.14)
Message:
2072 – GPS signal
No reception at starting pt. 2
Possible cause:
– Starting point 2 is in a dead spot
Remedy:
– Change the position of starting point 2
(Ö 11.14)
Message:
2073 – GPS signal
No reception at starting pt. 3
Possible cause:
– Starting point 3 is in a dead spot
Remedy:
– Change the position of starting point 3
(Ö 11.14)
Message:
2074 – GPS signal
No reception at starting pt. 4
Possible cause:
– Starting point 4 is in a dead spot
Remedy:
– Change the position of starting point 4
(Ö 11.14)
Message:
2075 – GPS signal
No reception in desired zone
Possible cause:
– The desired zone is in a dead spot
Remedy:
– Redefine the desired zone (Ö 10.)
Message:
2076 – GPS signal
Desired zone not found
Possible cause:
– The desired zone could not be found
during edge following
Remedy:
– Redefine the desired zone. Make sure
that the desired zone and perimeter
wire overlap (Ö 10.)

Stihl RMI 632 P Specifications

General

Brand	Stihl
Model	RMI 632 P
Category	Lawn Mower
Language	English