Stihl SGA 85 - Cleaning the Filter; Cleaning the Nozzle

0458-600-8221-A
29
English 20 Cleaning
To clean the sprayer:
► Clean the sprayer's polymer components, couplings and
connectors with a slightly dampened cloth. Do not use
abrasives or solvents that may damage the sprayer's
polymer components.
► Do not use a pressure washer to clean the unit. Never
spray the unit with water or other liquids.
► Keep the battery housing and guides free from foreign
matter and clean as necessary with a soft brush or soft,
dry cloth.
20.2 Cleaning the Filter
A clogged filter can cause excessive pressure to build in the
pump. Clean the filter if it becomes clogged.
To clean the filter in the container:
► Remove cap (1) and strainer (2).
► Take the filter (4) out of the container (3).
► Rinse the filter under running water.
► Fit the filter on the connector (5) and push it down until it
stops.
To clean the filter in the spray gun:
► Remove the control handle (3) from the spray gun (1).
► Remove the filter (2) from the spray gun.
► Rinse the filter under running water.
► Insert the filter into the spray gun and tighten by hand.
► Fit the control handle on the spry gun and tighten firmly by
hand.
20.3 Cleaning the Nozzle
A clogged nozzle can cause excessive pressure to build in
the pump. Clean the nozzle if it becomes clogged.
To clean the nozzle:
► Remove the nozzle (1) from the connecting piece (2).
► Disassemble the nozzle.
1
2
3
5
4
0000-GXX-B479-A0
2
1
3
0000098921_001
2
1
0000-GXX-C167-A0