Stihl SR 440 - Assembling the Unit; Fitting Pleated Hose to Elbow; Adjusting and Securing Control Handle

SR 440
English
40
N Push the ring seal (3) (wide lip
facing left) onto the stub on the
blower tube (2).
N Push the pleated hose (4) over the
ring seal (3).
N Push the hose clamp (1) onto the
pleated hose (4).
N Line up the marks on the hose
clamp (1) and blower tube (2) – as
shown.
N Secure the hose clamp (1) with the
screw (5) – the blower tube (2) must
still rotate.
Fitting the Pleated Hose on the Elbow
N Push narrow hose clamp (1), marks
facing left, onto the elbow (2).
N Push the pleated hose (3) onto the
elbow (2).
N Push the hose clamp (1) onto the
pleated hose (3).
N Line up the marks on the hose
clamp (1) and elbow (2) – as shown.
N Secure the hose clamp (1) with the
screw (4).
Adjusting and Securing the Control
Handle
N Put the machine on your back and
adjust the harness – see "Harness".
N Slide the control handle (1) along
the tube to the most comfortable
position – distance between nozzle
outlet (2) and the control handle (1)
must be at least 500 mm ('a').
N Secure the control handle (1) with
the screw (3).
2
3
0002BA074 KN
4
5
4
0002BA075 KN
1
2
2
1
0002BA076 KN
3
1
4
3
1
4
0002BA077 KN
2
2
a
1
0002BA011 KN
2
0002BA058 KN
1
3