SR 440
English
45
N Press the manual fuel pump
bulb (3) at least five times – even if
the bulb is filled with fuel.
Cold engine (cold start)
N Press in the choke knob (4) and turn
it to c.
Warm engine (warm start)
N Press in the choke knob (4) and turn
it to o.
Also use this setting if the engine has
been running but is still cold.
Cranking
N Place the unit securely on the
ground and make sure that
bystanders are well clear of the
nozzle outlet.
N Make sure you have a firm footing:
Hold the unit with your left hand on
the housing and put one foot against
the base plate to prevent it slipping.
N Pull the starter grip slowly with your
right hand until you feel it engage
and then give it a brisk strong pull.
Do not pull out the starter rope to full
length – it might otherwise break.
N Do not let the starter grip snap back.
Guide it slowly back into the housing
so that the starter rope can rewind
properly.
N Continue cranking until the engine
runs.
As soon as the engine runs
N Pull the throttle trigger – the choke
knob (4) automatically returns to the
run position (e).
At very low outside temperatures
N Open throttle slightly – warm up the
engine for a short period.
To Next Page
Loading...
