Stihl TS 400 - Page 46

45TS 400
English / USA
Definitions
1. Rear Handle:
The support handle for the right
hand.
2. Air Filter:
Prevents dust and foreign matter
from entering the carburetor.
3. Wingnut of Filter Cover:
For removing filter cover; permits
filter to be cleaned.
4. Throttle Trigger Interlock:
Must be depressed before
activating the throttle trigger.
5. Throttle Trigger:
Controls the speed of the engine.
6. Choke Lever:
Eases engine starting by enriching
mixture.
7. Control Lever:
Starting throttle lock and stop
switch. Keeps the throttle partially
open during starting, switches the
engine's ignition off and stops the
running of the engine.
8. Spark Plug Terminal:
Connects the spark plug with the
ignition wire.
9. Front Handle:
Handle bar for the left hand at front
of cut-off machine.
10. Wheel Guard:
Guards the wheel and deflects
sparks, dust, cutting debris or wheel
fragments.
11. Thrust Washer:
Distributes clamping pressure of
mounting nut evenly over cutting
wheel.
12. Abrasive Wheel:
Can either be an abrasive wheel or
a diamond abrasive wheel.
13. Adjusting Lever of Wheel Guard:
To adjust the wheel guard in a way
that sparks, dust, cutting debris or
wheel fragments are directed away
from the operator.
14. Muffler:
Attenuates exhaust noises and
diverts exhaust gases in required
direction.
15. Tensioning nut:
For tensioning the V-belt.
16. Starter Grip:
The grip of the pull starter which is
the device to start the engine.
17. Fuel Filler Cap:
For closing the fuel tank.
18. Decompression valve:
Makes starting easier.
19. Water attachment:
For connection of water supply for
wet cutting.
Clutch:
Couples engine to the V-belt pulley
when engine is accelerated beyond idle
speed. (Not illustrated)
V-Belt Pulley:
The wheel that drives the V-belt and the
abrasive wheel. (Not illustrated)