Stihl TS 460 - Abrasive Wheels; Transport and Storage

19TS 460
English / USA
This machine is equipped with an
automatic, spring-loaded V-belt
tensioning device.
Before tensioning the V-belt, the
: hexagon bolts (1) must be
unscrewed and the arrow on the
tensioning nut (3) must point to "0",
otherwise:
: Unscrew the hexagon bolts and turn
the tensioning nut approx. 1/4 turn
counterclockwise as far as the
stop = "0" with the combination
wrench
To tension the V-belt,
: fit the combination wrench over the
tensioning nut as illustrated
The tensioning nut is
spring-loaded – the combination
wrench must therefore be held
securely!
: Turn the tensioning nut clockwise.
The spring force begins to act on the
tensioning nut after approx. 1/8 turn;
it is then turned on as far as the stop
(approx. 1/8 turn)
Do not use force to turn the combination
wrench!
The V-belt is automatically tensioned
by the force of the spring in this position.
: Remove the combination wrench
and tighten the hexagon bolts (1)
Retensioning
The V-belt is retensioned without
adjusting the tensioning nut.
: Unscrew the hexagon bolts (1)
The V-belt is automatically tensioned
by the force of the spring.
: Retighten the hexagon bolts
Tensioning the V-belt
337BA020 LA
337BA021 LA