Stihl TS 700 User Manual

13TS 700, TS 800
English / USA
!Warning!
It is essential to determine the exact
direction of the cut before applying the
abrasive wheel to the work. Wheels are
constructed for radial pressure only.
Lateral pressure must be avoided. Hold
the cut-off machine steady. To reduce
the risk of serious or fatal injury, do not
change the direction of the cut during the
cut as this may produce a high torsional
load on the abrasive wheel and may
cause it to break or shatter.
!Warning!
Do not use abrasive wheels for rough
grinding. Large bending stresses occur
during such work and abrasive wheels
may shatter or break and could cause
serious or fatal injury.
!Warning!
To reduce the risk of injury from
shattered abrasive wheels:
1. Do not exceed the maximum
operating speed marked on the
wheel.
2. Do not use a wheel that has been
dropped.
3. Test each new wheel immediately
after installation for approximately
one minute at maximum speed
without cutting, making sure to keep
bystanders away.
4. Do not cut any material for which the
abrasive wheel is not authorized.
5. Do not grind on the side of the
abrasive wheel.
6. Do not twist, thrust, knock or drop
the machine. This can cause
damage to the wheel.
To achieve a clean and efficient cut, pull
the abrasive wheel across the work or
move it "to and fro" in the cutting
direction. Do not use force to push the
abrasive wheel into the work.
Insert the wheel into the material only as
deep as necessary to make the cut. To
reduce the amount of dust created, do
not cut all the way through stone and
concrete materials - leave a thin piece
uncut. For most such materials, this
piece can be easily broken afterwards.
Do not cock, jam or wedge the wheel in
the cut.
Always stop the engine and be sure the
wheel has stopped rotating before
setting down the cut-off machine.
If a cut-off machine cart is used, sweep
debris from the path of the wheels, as
debris under one of the cart’s wheels
may cause flexing of the abrasive wheel.
This could result in high frictional forces
and thus greatly reduce the engine
power available for the actual cutting
work. It could also damage the abrasive
wheel.
STIHL recommends the use of the cart
for longer cuts in a straight line.
Wet Cutting with Abrasive Wheels
Before wet cutting, make sure water will
not damage the floor or building.
!Warning!
To reduce the risk of electrocution to you
or bystanders, do not allow water or
sludge to contact live electric wires.
!Warning!
To reduce the risk of injury from wheel
breakage when wet cutting with a
composite non-diamond wheel:
1. Never store and re-use a wheel that
has been used with water. Use
these wheels up the same day.

Stihl TS 700 Specifications

General

Maximum Wheel Size	350 mm
Maximum Cutting Depth	125 mm
Cutting Depth	125 mm
Sound Power Level	113 dB(A)
Displacement	98.5 cc
Weight	11.6 kg
Fuel Capacity	1.20 L
Arbor Size	20 mm
Fuel Tank Capacity	1.2 l (40.6 oz.)