27TS 700, TS 800
English / USA
: Fit the bearing (9) with guard on the
outboard side of the cast arm,
guiding the V-belt over the belt
pulley at the same time.
: Refit the V-belt guard.
: Line the threaded holes in the
bearing up with the oblong holes in
the cast arm and with the holes in
the V-belt guard.
: Screw in the hexagon bolts, but do
not tighten them yet.
: Insert the longer banjo bolt (1)
through the
: connector (2) of the water
attachment.
: Note the connector position.
: Insert the square nut into the guide
in the connector and hold it in place.
: Fit the water attachment on the
adjusting lever with the longer banjo
bolt and tighten down the banjo bolt.
Continue as described in the chapter
"Tensioning the V-belt".
Version B (TS 700, TS 800)
: Disassemble the cutting wheel (see
"Fitting / replacing a cutting wheel").
: Move the guard to the position
illustrated and
: pull out the plugs (arrows).
: Fit the adjusting lever (1) in position
A.
: Press the plugs into the free holes.
: Unscrew the nuts (2).
: Take out the banjo bolts (3).
376BA050 KN
9
1
376BA063 KN
1
2
A
1
376BA051 KN
To Next Page
Loading...
