50
English / USA
TS 700, TS 800
EPA / CEPA:
The Emission Compliance Period
referred to on the Emissions
Compliance Label indicates the number
of operating hours for which the engine
has been shown to meet Federal
emission requirements.
Category:
A = 300 hours,
B = 125 hours,
C = 50 hours
CARB:
The Emission Compliance Period used
on the CARB-Air Index Label indicates
the terms:
Extended = 300 hours,
Intermediate = 125 hours,
Moderate = 50 hours
Engine
STIHL single cylinder two-stroke engine
Ignition System
Type: Electronic magneto ignition
Spark plug (suppressed):
Bosch WSR 6 F, NGK BPMR 7 A
Electrode gap 0.02 in (0,5 mm)
Diaphragm carburetor
All position, with integrated fuel pump
Air filter
Main filter (paper filter) and flocked
supplementary wire mesh filter
Fuel tank capacity
2.5 pt (1,2 l)
Abrasive wheels
Max. wheel thickness 6 mm (0.236 in).
Use only composite abrasive wheels
marked „high speed reinforced“ or
diamond abrasive wheels. All wheels
must be approved for use on handheld,
portable cutting-off machines and meet
the requirements of ANSI B7.1.
Composite abrasive wheels and
Diamond abrasive wheels
TS 700: 14 in dia. (350 mm)
TS 800: 16 in dia. (400 mm)
Arbor hole diameter, spindle
diameter
0.787 in (20 mm)
Min. thrust washer diameter
4.1 in (103 mm)
Cutting depth with thrust plate
dia. 4.1 in (103 mm):
TS 700: max. 4.9 in (125 mm)
TS 800: max. 5.6 in (143 mm)
Specifications
Displacement: 6.0 cu.in
(98,5 cm
3
)
Bore: 2.2 in
(56 mm)
Stroke: 1.57 in
(40 mm)
Idle speed: 2200 rpm
Maximum spindle speed
TS 700 with dia. 14 in
(350 mm):
TS 800 with dia. 16 in
(400 mm):
(make sure that the
maximum operating
wheel speed is above or
equal to the maximum
spindle speed of your
cut-off machine)
5350 rpm
4600 rpm
To Next Page
Loading...
