Stihl TS 700 - Page 8

7TS 700, TS 800
English / USA
1. Stone
Also can be used for concrete,
masonry, reinforced concrete and
brick cutting.
2. Steel
Can be used for all ferrous metal
cutting.
3. Asphalt
Also can be used for aggregate
concrete cutting.
4. Ductile iron
Also can be used for certain grades
of cast iron (SG 17-24), bronze and
copper cutting.
For cutting composite materials please
ask your STIHL dealer.
Diamond Abrasive Wheels
Diamond abrasive wheels have a much
better cutting performance than
composite abrasive wheels. The
diamond wheels are steel centered, and
diamond particles are imbedded in their
cutting edges.
They can be used for concrete, asphalt,
natural stone, clay pipe, brick and the
like.
They are not normally suitable for
cutting metal or other materials.
Wet or dry cutting is possible. With wet
cutting your diamond wheel will have a
longer life. Water attachments are
included with your STIHL cut-off
machine. See the appropriate section of
your instruction manual.
!Warning!
Do not remount a used diamond
abrasive wheel without first inspecting
for under-cutting, flatness, core fatigue,
segment damage or loss, signs of
overheating (discoloration) and possible
arbor hole damage.
Check the wheel for cracks and make
sure that no pieces have broken off the
wheel before use.
Always fit the wheel so that the arrow on
the wheel points in the direction of the
rotation of the spindle.
THE USE OF THE CUT-OFF
MACHINE
Transporting the STIHL Cutquik
!Warning!
Always stop the engine before putting a
cut-off machine down or carrying it. The
abrasive wheel continues to rotate for a
short while after the throttle trigger is
released (flywheel effect). Carrying a
cut-off machine with the engine running
is extremely dangerous. Accidental
acceleration of the engine can cause the
wheel to rotate. Avoid touching the hot
muffler.
By hand: When carrying your cut-off
machine by hand, the engine must be
stopped and the cut-off machine must
be in the proper position. Grip the front
handle and place the muffler at the side
away from the body.
!Warning!
Always protect the cutting wheel from
hitting the ground or any other objects.
Damaged wheels may shatter and
cause serious or fatal injury.