TS 800
English
13
N Always start at the bottom, use the
upper quarter of the abrasive wheel
for cutting
N Use the upper quarter of the
abrasive wheel for cutting the
opposite lower side.
N First lateral cut on the top half of the
pipe
N Second lateral cut in the marked
area – never cut into the area of the
last cut, to ensure a firm hold on the
part of pipe to be cut
Only make the last top cut once all
bottom and lateral cuts have been
made.
N Last cut always from the top
(approx. 15 % of the pipe
circumference)
Concrete pipe – cut recess
Sequence of cuts (1 to 4) is important:
N First, cut hard-to-reach areas
N Always make severing cuts so that
the abrasive wheel is not pinched
N Use wedges and/or leave ridges
that are broken after cutting
N If the severed part remains in the
recess after cutting (due to wedges,
ridges used), do not make any
further cuts – break the severed part
002BA560 AM002BA561 AM
To Next Page
Loading...
