TSA 230
English
24
Cutting wheels are exposed to
extremely high loads especially during
hand-held cutting.
Only use abrasive wheels that comply
with ANSI B 7.1 for hand-held machines
and are correspondingly labeled. Note
that the maximum permissible speed
rating of the cutting wheel must be
higher than the maximum spindle speed
listed on the wheel guard label.
The cutting wheels that have been
developed for STIHL by well-known
manufacturers of abrasive wheels are of
high quality and tailored precisely to the
respective intended use as well as the
engine performance of the cut-off
machine.
Types:
– for dry applications
– for wet applications
Economic benefit is improved and
premature wear can be avoided by
choosing and using the correct
composite resin cutting wheel. The short
name (e.g. “asphalt“, “concrete“) on the
label can help to ensure the correct
choice.
STIHL composite resin cutting wheels
are suitable, depending on the version,
for cutting the following materials:
– Stone
– Ductile cast pipes
– Steel; STIHL composite resin
cutting wheels cannot be used to cut
railway tracks.
– Stainless steel
Do not cut any unauthorized materials –
risk of accident!
Storage
– Do not expose cutting wheels to
direct sunshine or other thermal
stresses during transport and
storage.
– Avoid jolting and impacts.
– Stack cutting wheels flat on a level
surface in the original packaging in
a dry place where the temperature
is as constant as possible.
– Do not store cutting wheels in the
vicinity of aggressive fluids.
– Store cutting wheels in a frost-free
place.
Cutting wheels Composite resin cutting
wheels
To Next Page
Loading...
