Stihl TSA 230 - Page 40

TSA 230
English
38
Charge Times
Abrasive wheels
The quoted maximum permissible
operating speed of the abrasive wheel
must be greater than or equal to the
maximum spindle speed of the cut-off
machine used.
Weight
Water supply
Transporting batteries
STIHL batteries comply with the
requirements set forth in UN-Manual
ST/SG/AC.10/11/Rev.5/Part III,
Subsection 38.3.
Commercial air, vessel and ground
transportation of lithium ion cells and
batteries is regulated. The battery is
classified as a UN 3480, Class 9,
packaging group 2 product. Shipping it,
either as a complete tool or the battery,
requires compliance with all applicable
shipping regulations. Check with the
ground, vessel, air cargo or passenger
airline to determine if transport is
prohibited or subject to restrictions or
exemptions prior to shipping or travel.
Normally, no further conditions have to
be fulfilled by the user to transport
STIHL batteries by road to the power
AL 100
with AP 80:
– up to 80 % capacity: 70 min
– up to 100 % capacity: 100 min
with AP 115:
– up to 80 % capacity: 110 min
– up to 100 % capacity: 140 min
with AP 160:
– up to 80 % capacity: 150 min
– up to 100 % capacity: 165 min
with AP 180:
– up to 80 % capacity: 160 min
– up to 100 % capacity: 210 min
AL 300
with AP 80:
– up to 80 % capacity: 25 min
– up to 100 % capacity: 50 min
with AP 115:
– up to 80 % capacity: 25 min
– up to 100 % capacity: 55 min
with AP 160:
– up to 80 % capacity: 35 min
– up to 100 % capacity: 60 min
with AP 180:
– up to 80 % capacity: 40 min
– up to 100 % capacity: 70 min
AL 500
with AP 80:
– up to 80 % capacity: 25 min
– up to 100 % capacity: 50 min
with AP 115:
– up to 80 % capacity: 20 min
– up to 100 % capacity: 25 min
with AP 160:
– up to 80 % capacity: 35 min
– up to 100 % capacity: 60 min
with AP 180:
– up to 80 % capacity: 25 min
– up to 100 % capacity: 30 min
Max. spindle speed: 6650 rpm
Outside diameter: 230 mm
(9 ")
Max. thickness 3 mm
Bore diameter/spindle
diameter:
22.23 mm
(7/8 ")
Tightening torque: 20 Nm
(177 lbf. in.)
Composite resin abrasive wheels
Minimum outside diameter
of thrust washers:
80 mm
(3.150 in.)
Max. depth of cut: 70 mm
(2.756 in.)
Diamond abrasive wheels
Minimum outside diameter
of thrust washers:
80 mm
(3.150 in.)
Max. depth of cut: 70 mm
(2.756 in.)
without battery, without
abrasive wheel, with water
connection
3.9 kg
(8.6 lbs.)
Max. pressure of water
supply:
4bar
(58 psi)