TSA 230
English
39
tool’s operating site. Check and comply
with any special regulations that may
apply to your situation.
FCC 15 Compliance Statement for
power tool and charger
This device complies with part 15 of the
FCC Rules. Operation is subject to the
following two conditions:
– this device may not cause harmful
interference.
– this device must accept any
interference received, including
interference that may cause
undesired operation.
Note: This equipment has been tested
and found to comply with the limits for a
Class B digital device, pursuant to part
15 of the FCC Rules. These limits are
designed to provide reasonable
protection against harmful interference
in a residential installation. This
equipment generates, uses and can
radiate radio frequency energy and, if
not installed and used in accordance
with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause
harmful interference to radio or
television reception, which can be
determined by turning the equipment off
and on, the user is encouraged to try to
correct the interference by one or more
of the following measures:
– reorient or relocate the receiving
antenna,
– increase the separation between
the equipment and receiver,
– connect the equipment into an
outlet on a circuit different from that
to which the receiver is connected,
– consult the dealer or an
experienced radio/TV technician for
help.
Do not change or modify this product in
any way unless specifically allowed in
this manual, since this could void your
authority to operate it.
To Next Page
Loading...
