4 Operation
Lifting
– Sit down on the driver's seat.
All the relevant functions of the working
hydraulics will be available again.
NOTE
If it is not possible to release the block on the
hydraulics when the load is raised because
of a technical fault, the load must be lowered
using the "emergency lowering" mechanism
before any further action is taken. Do not
operate the truck again until the fault has been
rectified by the authorised service centre.
Lifting system operating devices
The method of operating the lifting system
depends on the operating devices included in
the truck's equipment.
Possible equipment variants include:
• Double mini-lever
• Triple mini-lever
• Quadruple mini-lever
• Joystick 4Plus
• Fingertip switch
– The following information must be observed
regardless of the equipment variant:
DANGER
Reaching into or cl
imbing between moving parts
of the truck (e.g. li
ft mast, sideshifts, working
equipment, load c
arrying devices etc.) can lead to
serious injury o
r death and is therefore prohibited.
– Observe the saf
ety regulations for handling
loads.
– Only operate the
lifting system from the driver's
seat.
154
56358042501 EN - 10/2018
To Next Page
Loading...
