11
Getting Started
Unpacking
• Unpack: Remove all packing materials from outside and inside the oven. If
there is a safe film over the oven door, tear it off before use. Keep the original
packaging carton and materials in a safe place. It will help prevent any
damage if the product needs to be transported in the future, and you can use
it to store the appliance when it is not in use. In the event it is to be disposed
of, please recycle all packaging materials where possible. Plastic wrapping
can be a suffocation hazard for babies and young children, so ensure all
packaging materials are out of their reach and disposed of safely.
• Inspect: Unwind the power supply cord to its full length and inspect it
for damage. Then check the microwave oven for any damage, such as a
misaligned or bent door, damaged door seals and sealing surfaces, broken or
loose door hinges and latches, dents inside the cavity or on the door.
WARNING: If there is any damage to the appliance or its cord, do not operate
the microwave oven! Contact our after sales support centre.
• Read: Read this manual to familiarise yourself with the parts and operating
principles. Pay particular attention to the safety advice on the previous pages.
• Clean: Wipe the inside surfaces of the microwave oven with a damp cloth.
Wash the glass turntable with a soft cloth in warm water and a little dish
detergent to remove any dust from transport. Rinse and dry thoroughly.
Installation
• Position: Place the microwave oven on a flat, stable surface that can support
the weight of the oven plus the heaviest foods likely to be cooked in it.
• WARNING: Do NOT place the microwave oven:
X In a cabinet; this appliance is intended to be used freestanding.
X Where heat, moisture or high humidity are generated (such as near a gas
burner or water tank).
X Near combustible materials.
X Near a TV, radio or antenna; keep a minimum distance of 5m to such
appliances in order to avoid potential picture interference.
• Clearances: Place the microwave oven with its back against a wall, allowing
enough space for ventilation: 20cm of space above the oven, 10cm at the
back and 5cm on both sides. Do not cover or block any openings on the
appliance. Do not remove the feet. Only use the appliance on a benchtop that
is at least 85cm above the ground.
• Assembly: Place the rotating ring in its position in the cavity base and the
rotating axis in the centre. Then fit the turntable on top, making sure it sits
securely in place and can move freely on the rotating ring.
WARNING: Do not operate the appliance without the turntable, rotating ring
and rotating axis in their proper positions.
To Next Page
Loading...
