Demonstration software UM1879
8/41 UM1879 Rev 4
5 Demonstration software
The demonstration software, included in the STM32Cube MCU Package corresponding to
the on-board MCU, is preloaded in the STM32 Flash memory for easy demonstration of the
device peripherals in standalone mode. The latest versions of the demonstration source
code and associated documentation can be downloaded from the
www.st.com/stm32l4-
discovery web page.
6 Ordering information
To order the 32L476GDISCOVERY Discovery kit, refer to Table 1.
7 Delivery recommendations
Some verifications are needed before using the board for the first time to make sure that
nothing has been damaged during the shipment and that no components are unplugged or
lost. When the board is extracted from its plastic bag, check that no component remains in
the bag. In particularly, make sure that the following jumpers on top side of the board are
plugged: CN3, JP3, JP5, and JP6.
The battery CR2032 is not provided.
8 Conventions
Table 2 provides conventions used in the present document.
Table 1. Ordering information
Order code Target STM32
32L476GDISCOVERY STM32L476VGT6
Table 2. ON/OFF conventions
Convention Definition
Jumper JPx ON Jumper fitted
Jumper JPx OFF Jumper not fitted
Solder bridge SBx ON SBx connections closed by solder
Solder bridge SBx OFF SBx connections left opened
To Next Page
Loading...
Need help?
General
