- 16 -
OPERATION
NEVER POUR OR SPRAY WATER ON
THE MOTOR.
NEVER PLACE HANDS OR ANY
OBJECT INTO THE DRUM WHILE
THE MOTOR IS RUNNING.
ALWAYS DISCONNECT THE
ELECTRIC CORD WHEN CLEANING
INSIDE THE DRUM.
MAINTENANCE and LUBRICATION
To get long and trouble-free service from this mixer,
it is essential that you perform periodic maintenance.
Adjust belt as required by loosening the (4) motor
mount bolts and moving motor as necessary.
Retighten these bolts after adjustment. The belt
should deflect approximately 1/4 inch at the halfway
point when 5-10 lbs of pressure is applied.
Adjust pinion/gear mesh as required by loosening
the two (2) pinion jackshaft bolts and moving
jackshaft as necessary. Retighten these bolts after
adjustment.
Grease after each use through the (2) fittings
provided. Use any Grade #1 lithium based grease.
DO NOT grease or oil the gear. This will attract
sand and cause excessive wear.
WARNING
How to Mix Concrete
1. You will need approximately 2-1/2 gallons
of water
2. 2-80 lb. bags of pre-mix concrete
3. Start mixer in motion
4. Put in 2-gallons of water
5. Add 1-80 lb. bag of pre-mix concrete
Note: Mixture will be very sloppy
6. Slowly add second bag of concrete
7. Add ½ gallon of water slowly to obtain
desired thickness
How to Mix Sand and Gravel
1. Use an 8-1/2 x 12-inch square point shovel
2. Portland cement, gravel or round stone and
masonry sand
3. Start mixer in motion
4. Put in 2 gallons of water
5. Add 6 shovels full of gravel or round stone
6. Add 2 shovels full of Portland Cement
7. Slowly add 4 shovels full masonry sand
Note: Water will vary according to moisture
content of sand and gravel
How to Mix /How to Mix Sand &
Gravel/Maintenance & Lubrication
To Next Page
Loading...
