- 17 -
Maintenance
25CMPT Pedestal Assembly
PEDESTAL MODEL ASSEMBLY
WHENEVER ASSEMBLING,
LUBRICATING OR ADJUSTING ANY
PART OF THE MIXER, DISCONNECT
THE POWER PLUG.
To attach motor (6) to frame assembly (4), line up
motor to match the four holes on the side motor
mount. Attach the V-belt (8) to the motor pulley (7).
Using the four 5/16 x ¾ in Hex Flange Screws (31)
and four 5/16 Hex Flange Lock Nuts (32), secure
the motor in place. The V-belt should be tightened
until the belt deflects approximately ¼ in when 5-10
pounds of force is applied centrally between the
pulleys. Assemble base legs (1 and 2). Assemble
Yoke (3) to assembled base and pin (29). Using two
people, lift and place Frame Assembly (4) onto Yoke
(3) pivot pins and insert pins (26). Slide dump
handle Grip (19) over the end of the Dump Handle
(18) and insert the Handle in the Frame Assembly
(4).
GREASE
Using a grease gun, apply grease to the Fitting (24)
on the Jackshaft Tube if not already greased at
factory. Plug in the Power Cord. Let the motor run
for about 5 to 8 minutes, then turn off motor. This
will break-in the jackshaft bushings.
KEEP HANDS AND CLOTHING
AWAY FROM MOVING JACKSHAFT
AND GEAR.
Place Thrust Washer (25) onto Drum Shaft (15) and
lightly grease the shaft. Using two people, carefully
slide the Drum assembly with shaft into the tube
located centrally on the Frame (4). Check to see that
the Jackshaft Gear (10) is properly meshing with the
Drum Main Gear (14). Place locking Collar (17)
onto Shaft (15) and tighten setscrew.
Grease the Fitting (24) on the Drum Shaft tube until
grease appears near the locking Collar (17) and the
Thrust Washer (30).
Check the clearance of Gear Guard (21) and the
Drum (5) to make sure there is no contact between
the rotating Drum and the Guard.
LUBRICATION
Any grease fittings (Item 24) require an application
of any type EP grease after each use. Apply grease
until grease begins to come out of the bushings.
Lubricate before each use of the mixer.
WARNING
WARNING
To Next Page
Loading...
