Do not lift the appliance by the
door handle
■ Remove the fixing screws from the
polythene bag on the top of the
appliance, but leave the appliance
in the base tray packaging until you
are ready to install it.
■
NOTE: When removing the appli-
ance from the base tray packaging
care should be taken to ensure the
outer frame trim is not damaged.
❏ When installed in a typical 600 mm
deep built in housing unit, the false
back should be removed from the
housing unit, to provide the neces-
sary depth for installation.
❏ When the false back is removed, it
is normally the case that the support
shelf for the appliance leaves a gap
between the back edge of the sup-
port shelf and the rear wall of
approximately 80 mm.
❏ If no gap occurs between the back
edge of the shelf and the wall
behind the unit, we recommend that
a gap of at least 30 mm is made by
shortening the support shelf.
❏ If a top shelf is fitted, it must have a
gap at the rear of at least 50 mm,
but ensure items will not be dropped
behind the oven.
I
MPORTANT: DO NOT MODIFY THE OUTER
PANELS OF THIS APPLIANCE IN ANY WAY
.
INSTALLATION INSTRUCTIONS
To Next Page
Loading...