16
Insert the lower complete denture into the patient’s mouth and
check the clearance. The Matrix Housings fixed on the abutments
should not touch the denture base. Reconfirm adequate space using
wash impression silicone. Adjust the denture base until seated pas-
sively in occlusion without touching the Matrix Housings.
Prepare the recess in the lower complete denture with monomer.
Protect areas where you don’t want the resin with a thin layer of
petroleum jelly.
Fill the hollowed area with self-curing PMMA resin to polymerize the
Matrix Housings in the denture.
Apply a small amount of acrylic resin to the recess of the denture
base and around the Matrix Housings. Insert the lower complete
denture into the oral cavity.
Once the lower complete denture is properly seated, maintain the
patient in full occlusion while the acrylic sets.
Once the resin has cured, remove the lower complete denture from
the mouth and discard the white Novaloc® Mounting Collars.
Put the lower complete denture in hot, but not boiling, water. Place
it in a pressure pot when available.
4
5
6
7
8
490.115.indd 16 24/06/2019 14:02
To Next Page
Loading...