4.2 Assembly Steps – Motor
Step 1.
You will received 6 motors in
ALS800-CB.
Step 2.
For new motors, Thread Lock must be
applied to the two M3 Set Screws which is
pre-inserted in the motor.
(This is a must for safety flying.)
Step 3.
Install the Porp Mount to the motor using
3pcs M3 Hex Cap Screw. (Apply little
amount of Thread Locker when assembly
metal to metal parts.)
Step 4.
Double check the prop mount which must be
installed to the motor securely.
9
To Next Page
Loading...