Pull Stream
This section allows users of Streambox Cloud and Streambox Enterprise Server to pull streams from those
servers by matching the metadata of the stream being sent to the Server. This requires credentials for the
server and knowledge of the metadata, or else a Session ID.
IPv4: Set the IP (version 4) address of the Server from which the stream is to be pulled.
Port: Network port, usually 1770, to which the stream will connect.
Login & Password: Credentials to log in to the Server.
Group/DRM: The Group (also called DRM) found in the metadata of the stream being pulled from the Server.
Reporter: Should match the Reporter or Contributor metadata of the stream.
Once data has been entered, use a button to start pulling the stream:
Exec Pull-Mode Executes the pull mode and requests a specific stream, based on Reporter name and DRM,
from the server. When Pull Mode is enabled, it’s indicated in the status bar, upper right.
Set to Normal Mode: returns the unit to its normal Listen mode, where it awaits an incoming stream.
Port Selector
The Decoder is set to listen for its ACT-L3/L5 network stream on UDP port 1770. However if the Encoder and
network is set up for transport on another UDP port, the Decoder must be set to listen for the stream on that
port.
The port settings page allows the user to change the port on which the Decoder listens. To change the port,
click Edit, then enter an alternate port number.
Click Set to enable the changes.
To Next Page
Loading...