42
NOTE:
Always follow the safety instruction as described in the chapter “SAFETY INSTRUCTIONS -
Battery Safety”.
The micro TF card
The Test Mode
Memory card selection:
Choose a micro C10 TF card (Class 10: minimum write speed of 10MB/s) from a reputable brand
and use it on the Camera after formatting. It cannot be guaranteed that an ordinary dirt cheap
unbranded card will work properly.
Inserting the memory card:
Insert the memory card in the designated slot. The memory card should slide in freely with little
resistance. Continue pressing the card inward until you hear a click. The memory card is now locked
in place and ready for use.
Removing the memory card:
Before removing the memory card, turn the Camera o. Press and release the memory card to eject
it part way (to prevent the card from falling from the slot, press the center of the card and release
it slowly, without removing your nger from the card). The memory card can then be removed by
hand.
Move the switch to the "TEST" position and enter the setting mode. In this mode, like a normal
digital Camera, you can capture pictures or video, or enter the menu to set parameters. There are
six buttons on the keyboard.
To Next Page
Loading...
Need help?
General
