39
● This device is not a toy. Children can safely use Class 2 lasers only with continuous adult
supervision.
● Do not point the laser at persons’ or animals’ eyes or indirectly o reective surfaces.
● A Class 2 laser can be a distraction, glare, or ash blindness hazard for pilots and drivers. Never
aim any laser toward an aircraft or vehicle that is in motion. This is unsafe and illegal.
● Do not deliberately look into or stare into the beam. This can cause injury to the retina in the
back of the eye. The closer you are to the laser and the longer the beam is in the eye, the greater
the chance of injury.
● Do not look directly into the laser with optical tools (for example, binoculars, telescopes,
microscopes). Optical tools can focus the laser and be dangerous to the eye.
● Do not open the device. The laser beam is dangerous to the eyes.
● Put the power o before cleaning.
● A soft dry cloth is recommended for cleaning the exterior of the Digital Infrared Thermometer.
● Be careful while cleaning the lens. Blow o loose particles using clean compressed air. Carefully
wipe the surface with a clean moist cotton swab. The swab may be moistened with water.
● Be careful not to put too much pressure on the display and the buttons while cleaning.
● Do not immerse the device in water or any other liquids. It is not allowed to rinse the device with
water, to prevent the water from leaking into the electrical circuit and causing malfunctions.
● Under no circumstances use aggressive cleaning agents, cleaning alcohol, or other chemical
solutions since these can penetrate the housing or impair functionality.
● Do not use a wire brush, steel wool, or other abrasive objects for cleaning.
● Cleaning must not be performed by children.
Explosive Atmosphere
CLEANING
Do not use the Digital Infrared Thermometer in areas with a potentially explosive atmosphere,
such as areas where the air contains high levels of ammable chemicals, vapors, or particles
(such as grain, dust, or metal powders).
To Next Page
Loading...