Need help?Do you have a question about the Strom SBSP11C and is the answer not in the manual?
Guidance on heat loss, hot water, voltage/load calculations, and water pressure.
Guidance on connecting flow, return, and mains water pipes.
Steps for filling the heating system and adding inhibitor.
Procedure for filling the hot water circuit for combination boilers.
Checking for leaks on pipework and boiler internals after installation.
Guidance on supply cable size, isolator switch, and circuit breaker.
Checking installer and factory-made electrical connections for security.
Ensuring all previous steps are complete before powering on the boiler.
Setting clock, flow temperature, and differential settings via the control panel.
Steps for bleeding radiators and airvents to remove air from the system.
Testing the heating system by checking radiator warmth and temperature differential.
Testing the hot water output temperature and flow.
Table detailing potential causes and solutions for error codes E0-E8.
Table detailing causes and solutions for error codes E9, EA, and system issues.
To Next Page
General