Strom SSRTPR06 - Testing & Re-Pairing Controller and Receiver; Testing the Wireless Link; Re-Pairing Lost Wireless Link; Understanding Wireless Link Indicators

23
WWW.STROMLTD.COM
STROM LIMITED
TESTING & RE-PAIRING THE CONTROLLER & RECEIVER
Testing The Wireless Link Between Controller & Receiver:
For your convenience the thermostat and receiver come pre-paired,
however to test the link please simply:
1. Move the “FUNCTION SLIDER” to “MAN”.
2. Using the “ADUSTMENT SELECTORS” set the temperature to
over 30
o
C.
3. Check that the red “M/A” light on the receiver is lit and the boiler
has red. If it did not please re-check wiring & follow re-pairing
procedure below.
4. Move the “FUNCTION SLIDER” to “AUTO”
Re-Pairing The Wireless Link Between Controller & Receiver:
If your wireless receiver is no longer communicating with the controller
please ensure there is power to both devices and follow this procedure:
1. On the wireless receiver press and hold the “M/A” until the “Manual”
light begins to ash green (approximately 10 seconds).
2. On the Thermostat move the “FUNCTION SLIDER” to “OFF”.
3. On the Thermostat press & hold the “HOME FUNCTION” button
and the “HOLIDAY FUNCTION” button until “PAIR” is displayed on
the Thermostat.
4. The Thermostat will conrm the link by displaying “PAIR YES” and the
“Manual” green light on the receiver will stop ashing. If this does not
happen please re-check wiring, move the Thermostat closer to the
reciever and try again until you achieve pairing.
5. Test the wireless link in accordance with the above.
Visual Indicators Of Wireless Link:
The following symbols on the thermostat can be used to nd out more
about its wireless connection with the receiver.
9
4
9
2
7
The thermostat has no wireless link with the receiver, please re-
pair or move the thermostat closer to the receiver.
The thermostat has a wireless link with the receiver.
The thermostat and reciever are currently exchanging data.