Strom SSRTPR06 - Advanced Functions; Accessing the Advanced Functions Menu; Configuring Optimum Start; Configuring Optimum Stop

24
DELIVERING THE POWER
STROM LIMITED
To access the advanced functions of the controller ensure the “FUNCTION
SLIDER” is in the “OFF” position and simply press and hold for 5 seconds
the “HOME SELECTOR” & “DAY SELECTOR” .
To cycle through the options please use the “NEXT SELECTOR” , you can
amend the options using the “ADJUSTMENT SELECTORS” . Below is a
description of the functions and what they do. To exit the menu at any time
simply press the “HOME SELECTOR”.
Setting Optimum Start
The controller will display OP STAR
You can select OP dL StAr (optimum start), DS dL StAr (delayed start), or o.
Setting Optimum Stop
The controller will display OP STOP
You can select between on or o.
Setting TPI
The controller will display TPI
You can select either 3 cycles, 6 cycles, or o.
Setting the thermostat sensitivity
The controller will display SWING
You can set the temperature sensitivity of the controller from between
0.5
o
C and 2.0
o
C.
Setting the temperature calibration
The controller will display ADJ
You can set the temperature sensitivity of the controller from between
-3.0
o
C and +3.0
o
C.
Setting the number of timed events
The controller will display PROGRAM
You can set the number of timed events of the controller from between 4
and 6 events.
Setting the LCD contrast ratio
The controller will display LCD
If the contrast of the controller needs adjustment for its location simply set
it to a level that becomes readable between 4:6 (fainter) and 5:2 (stronger).
INSTALLATION GUIDE
ADVANCED FUNCTIONS
5
2
3
4
9