Stromer ST1 - Interface Operation; Switching the Stromer On and Off; Support and Recuperation Mode Selection

23
1. sWitch on stroMer
Important note: When switching on, the pedal must be completely free of load.
2. sWitch oFF stroMer
3. select suPPort or recuPeration MoDe
interFace – OPERATION
2 sec.
2 sec.
ready
2 sec.
off
MANUAL RECUPERATION MODE
The energy recovery is normally activated upon braking.
It can also be activated manually by selecting the mode.
Select a «Recup-Mode» to recover energy and thereby
brake electrically.
SUPPORT MODE
The Stromer has four different modes:
1 – Eco (150%), 2 – City (200%), 3 – Tour (250%)
and 4 – Power (300%)
When idling (Zero mode), nothing is shown in the mode
display and the motor does not provide any support.
back continue
english