1.3 Accessories
Installation Instructions
Troubleshooting
Safety instructions/warranty cards
1 Remote control
2x batteries (AAA type)
HDMI cable
Power adapter (5 V 2 A, max. 10 W)
WARNING: The batteries should not be recharged, disassembled, electrically short-
circuited, be mixed or used with other types of batteries.
NOTE: For the appropriate usage with this device, use only power adapters as
listed below (in case of a necessary exchange):
Model: ASM-0502000; Manufacturer: Shenzhen Aosimai Technology Co.Ltd
The usage of other power adapters may cause damage to the device. Such
damage is not covered under warranty.
1.4 Usage of external USB devices
It is recommended to use USB 2.0 storage devices or higher. If your device is not compatible to
USB 2.0 specifications, playback and other functions of the IP Box might not work properly.
STRONG cannot guarantee compatibility with all types of USB devices such as web cams,
keyboards, mouse devices, storage devices.
STRONG cannot guarantee perfect operation when a HDD and a web cam are used at the same
time.
If you are going to use external USB HDDs (Hard Disk Drives), please consider that power
specifications may exceed the supported output of your box (max. 5 V/500 mA). If so, please
connect your USB HDD to an external power adapter.
It is advised not to store important information on USB storage devices used with the box.
Always make backups of data on your USB storage device before using it with this box.
STRONG will not take responsibility for any loss of information or circumstances caused by loss
of information.
2.0 YOUR IP BOX
2.1 DEFAULT PIN: 1234
2.2 Front Panel
Fig. 1
1. Status indicator: Indicates status of ON or OFF modes.
2. IR sensor: Receives Standby/On signal from the remote control.
5
To Next Page
Loading...
