Strong Super Trouper - Page 5

XST/003
INSTALLATION AND SETTING UP SPOTLIGHT
 THEXENONSUPERTROUPERisshippedinsectionswhichmustbeassembled.
TheFoldingBaseStandAssembly65826000(seeFigure6)isshippedcollapsed,andrequiresonly
foldingdownandpinningthefourbaselegs.
 WHENINSTALLEDinapermanentlocation,thelevelingfeetmustberemoved,and
theclearanceholesinthebaselegbracketsusedforhardware(usersupplied)toboltthebasetothe
oororplatform.Ifitisdesiredtohavetheunitportable,whenoperating,thelevelingfeetmustbe
adjusteddownuntiltheweightofthespotlighthasbeenshiftedfromthecasterstothelevelingfeet.
 THEINNERTUBEandsupportyokehasthreeholestopermitadjustingtheheightof
thespotlight.Thethreeholesareonfour-inchcentersandwillallowanopticalheightofapproximately
53inches,57inches,and61inchesaboveoorleveltotheopticalcenterofthelamphouseandlens
system.Thelevelingfeetmaybeadjustedthroughanadditionaltwoinchrange.Inserttheheightloca-
tionpin(Figure5,Item16)throughtheholeintheoutertubeandoneoftheholesintheinnertube.
 THEHORIZONTALSWINGandverticaltiltlockingknobsareontherighthand
(operating)sideoftheyokeassembly.Tightenbothoftheselockingdevices(Figure6,Items19&
21)securelybeforeattemptingtoplacethelamphouseandlenssystemonthesupportyoke.
 PLACETHELAMPHOUSEandlenssystemontheyokeassembly(Figure6,Item4),
withthespotsizecontrolhandletotherighthand(operating)side,thesameasthelockingcontrols
ontheyoke.Lineupthefourmountingholesinthebottomofthebaserailwithfourslottedholesin
thesupportyokeandsecurewiththefour5/16-18wingscrews.Thereare(2)setsoffourmounting
holestoinsurecorrectbalanceofthespotlightwithorwithouttheoptionalcolorboomerang.An
optionalCounterweightKit(7201191)isalsoavailableforsettingconcisebalanceadjustments.
 THEOPTIONALCOLORBOOMERANG(7201188)mountstothefrontopening
oftheopticalsystemonthreestudsprotrudingfromthefrontoftheopticalsystemhousing.Secure
theboomerangusingthe(3)screwsprovided,andinstallthesafetycablebetweentheboomerang
housingandthespotlightframe.


ATTACHTHELAMPHOUSECABLECONNECTORtothereceptacleonthexenon
powersupply.Alignthepinsbeforetighteningthelockingring.Donotenergizethepowersupply
beforerstcompletingthebulbinstallationprocedure.
 CHECKTHE“CONS/SPOT”SLIDESWITCHonthexenonpowersupplycabinet
andverifythatithasbeenplacedintheappropriate“SPOT”position.Seetheillustrationonthe
insidefrontcoveroftheXenonPowerSupplyinstructionmanual.