Structural Concepts K Series - INSTALLATION: REMOVAL from SKID (LEVELERS and RAILS Vs. CASTERS)

6
1. Remove Case From Skid (Levelers and Rails)
 Remove shipping brace that may be securing case to
skid.
 Support case to prevent tipping.
 Caution! Levelers can be damaged if case hits floor
with heavy force!
Note: Case can be repositioned
with pallet truck when front lower
panel is removed. Blocking may
be necessary to obtain adequate
height.
Slide Skid Out
 Carefully slide unit to rear of
skid and tip backward off
skid.
 Illustration may not reflect
every feature or option of
your particular case.
2. Remove Case From Skid (Casters)
Remove shipping brackets that may be securing
casters to skid
 Place ramp up against skid (to allow case to
smoothly slide off from skid).
 Maintain support of case at all times or center
of gravity may cause case to fall.
 Unlock Casters. Roll unit to rear of skid.
Roll down ramp and off from skid.
Ramp
Caution!
Support while
rolling case
down ramp.
Note: Illustrations shown
reflect a general outline of
sample cases and do not
reflect features or options of
your particular model.
INSTALLATION: REMOVAL FROM SKID (LEVELERS AND RAILS vs. CASTERS)