Before each use
• Check the machine before each use.
• If you hang or carry the machine by the shoulder strap, make sure that the strap is intact and
that the buckle is correctly fastened.
WARNING
Do not operate the machine if there are visible cracks or damage to the unit, the
cables or to the grinding/polishing consumables to be used.
Battery pack
Rechargeable batteries have a limited lifetime which largely depends on use and charging
schedule.
To obtain the longest lifetime for the battery pack we recommend these maintenance procedures:
• If the battery pack has not been used for 3 months, recharge it.
• Do not allow the battery pack to become fully discharged.
7.3 Spare parts
For specific safety related parts, see the section "Safety Related Parts of the Control System
(SRP/CS)" in the section "Technical data" in this manual.
Technical questions and spare parts
If you have technical questions or when you order spare parts, state serial number and
voltage/frequency. The serial number and the voltage are stated on the type plate of the machine.
For further information, or to check the availability of spare parts, contact Struers Service. Contact
information is available on Struers.com.
7.4 Service and repair
We recommend that a regular service check be carried out yearly or after every 1500 hours of
use.
When the machine is started up, the display shows information about total operation time and the
machines service information.
After 1500 hours of operation time, the display will show a message reminding the user that a
service check should be scheduled.
Note
Service must only be performed by a qualified technician (electromechanical,
electronic, mechanical, pneumatic, etc.).
Contact Struers Service.
7 Maintenance and service
TransPol-5 25
To Next Page