To Next PageTo Next Page
Need help?Do you have a question about the Stryker Core 5400-050-000 and is the answer not in the manual?
General| Model | 5400-050-000 |
|---|---|
| Category | Medical Equipment |
| Type | Electrosurgical Generator |
| Power Source | AC |
| Voltage | 100-240 VAC |
| Frequency | 50/60 Hz |
| Compatibility | Compatible with Stryker accessories |
| Product Name | Stryker Core |
Details on Federal Communications Commission (FCC) compliance for the device.
Details on Industry Canada (IC) compliance and certification for the device.
Identifies the intended users of the manual, including trainers, physicians, nurses, and technicians.
Explains the symbols and conventions used throughout the manual for clarity and safety.
Provides details for obtaining additional information, support, or service from Stryker.
Step-by-step guide for connecting system components, including console, handpieces, and footswitches.
Defines fundamental buttons for navigation, selection, and basic operation of the console interface.
Defines buttons for advanced configuration, user preferences, and system management.
Adjusts the handpiece speed or power set point in RPMs or percentage of power.
Sets the direction and operating mode (e.g., forward, reverse, oscillate, high/low speed) for the handpiece.
Modifies the acceleration rate for the handpiece, from 0% to 100%.
Sets the braking percentage for the handpiece, controlling deceleration from 0% to 100%.
Sets the number of turns per direction for handpieces operating in oscillate mode.
Details on programming the TPS footswitch pedals and pads for handpiece control.
Details on programming the NSE footswitch pedals and pads for handpiece control.
Guides the user through assigning specific footswitch ports to connected handpieces.
Allows selection of specific handpiece attachments based on capability.
Assigns specific operational options to handpiece buttons based on capability.
Toggles the handswitch control function between ON and OFF.
Adjusts the percentage of torque control for the handpiece from 0% to 100%.
Allows selection or replacement of a preferred user preference file.
Guides the user through replacing an existing favorite user preference file.
Adjusts the irrigation flow rate percentage to the handpiece cutting accessory.
Activates the priming sequence for the installed irrigation cassette.
Provides a continuous flow rate to flush the irrigation tubing set.
Adjusts console volume, display brightness, and contrast settings.
Accesses user preference file management functions within advanced mode.
Allows selection of the console display language.
Accesses advanced settings for console configuration.
Adds a selected handpiece to the current user preference file.
Removes a selected handpiece from the current user preference file.
Provides a step-by-step procedure for cleaning and disinfecting the console.
Details console model, dimensions, mass, and equipment type.
Information on input voltage, power supply, and port specifications.
Details on the display screen characteristics and modes of operation.
Lists the safety standards and certifications applicable to the product.
