Inspection checklist
Refer to the Operating
Instructions for the
User’s Checklist
• Inspect the debrillator for
signs of damage, cracks or
foreign substances
• It is not necessary to switch
on the debrillator for the
inspection
• Observe the Readiness Display
on the top right and perform
the following checks:
1. The OK symbol is visible
2. The battery symbol shows
two or more bars
• Conrm spare, fully charged
battery is readily available
and in-date
• Ensure there is one pack
of QUIK-COMBO pads
preconnected to the
debrillator, and the pack of
pads is sealed and in-date
• There should be one
additional set of adult pads
• If present, check Infant/Child
Reduced Energy Debrillation
Electrodes to make sure they
are sealed and in-date
This is not the complete instructions for use. Refer to
Operating Instructions for complete device information
including directions for use, intended use and warnings.
Readiness
display
Battery is very low.
Replace immediately.
Battery is depleted.
Replace immediately.
Service symbol indicates
service is required.
Battery is fully charged.
OK indicates device
is ready for use.
LIFEPAK
®
1000 Defibrillator
Pocket guide