What to do if Stryker Sidne says "O. R. Lights Disconnected" or "Overhead Camera Disconnected"?
If the Stryker Medical Equipment displays a message saying "O. R. Lights Disconnected" or "Overhead Camera Disconnected", power off the device. Ensure that the device is properly connected to Sidne™. Power the device back on.
What to do if EDAM LED is flashing amber on Stryker Medical Equipment?
If the EDAM LED is flashing amber, it indicates that Sidne™ is not communicating properly with the Sidne™ device EDAM. Try the following steps: 1. Power off the EDAM. 2. Ensure Sidne™ is powered on. 3. Ensure that the Sidne™ interface cable is plugged into the EDAM. 4. Ensure that the Sidne™ interface cable is plugged into Sidne™. 5. Power on the EDAM.
What to do if EDAM LED is OFF on Stryker Sidne Medical Equipment?
If the EDAM LED is off, it means that the device is not communicating properly with the EDAM. To resolve this: 1. Power off the device. 2. Ensure that the device adapter cable is plugged into the EDAM. 3. Ensure that the device adapter cable is plugged into the Visum Power box control box. 4. Power on the device. 5. Ensure that the Visum wall panel controls do not show any error. If they do, then contact Technical Support.
General| Category | Medical Equipment |
|---|---|
| Manufacturer | Stryker |
| Model | Sidne |
| Compatibility | Stryker Navigation Software |
| Display | Integrated Touchscreen |
| Software | Stryker Navigation Software |
| Precision | Submillimetric |
Lists essential user responsibilities for safe operation and to prevent damage.
Explains the meaning of warning, caution, note, and specific symbols used in the manual.
States that the device is restricted by federal law for use by or on order of a physician.
Lists the main components included in the Sidne™ system package.
Details the primary component of the Sidne™ system, its ports, and functions.
Describes the remote-control tablet, its touch screen, and power options.
Explains the voice-activated control system, its components and their functions.
Step-by-step guide for connecting power, devices, and audio/video inputs to the console.
Instructions for setting up the remote-control tablet, referring to a separate insert.
Instructions for setting up the wireless microphone headset, including receiver connections.
Details on powering, setting frequency, and positioning the transmitter.
Instructions for connecting and positioning the microphone headset for use.
How to configure the system to display the correct camera input.
Explains how to navigate menus and issue commands using the tablet interface.
Details how to use voice commands to control the system and connected devices.
Lists voice commands that can be used from multiple menus.
Overview of commands for various compatible operating-room devices.
Tablet and voice commands for operating the arthroscopy pump.
Tablet and voice commands for controlling the medical video camera.
Tablet and voice commands for operating the high-flow insufflators.
Tablet and voice commands for controlling the light source.
Tablet and voice commands for operating the TPS shaver.
Tablet and voice commands for the digital capture system.
Tablet and voice commands for operating the video printer.
Tablet and voice commands for controlling the video cassette recorder.
Describes tablet menu options for console settings like web control, audio, and video source.
Lists voice commands for console options such as audio, video, and timer settings.
Displays the tablet interface for controlling the FloControl pump.
Lists voice commands for operating the FloControl arthroscopy pump.
Explains the feedback messages from the Sidne™ system related to the FloControl pump.
Shows the tablet interface for controlling the 1088 camera.
Lists voice commands for operating the 1088 camera.
Explains feedback messages from the Sidne™ system related to the 1088 camera.
Instructions for safely cleaning the Sidne™ console, tablet, and headset.
Information on system maintenance and fuse replacement.
Step-by-step guide for replacing fuses in the Sidne™ console.
Solutions for problems related to lack of voice command response.
Solutions for problems where no video signal is displayed.
Troubleshooting steps for poor video quality.
Solutions for when the system does not recognize voice commands.
Steps to resolve issues where compatible devices are not detected.
Troubleshooting for system errors indicated by audio feedback or LEDs.
Solutions for low battery warnings on the wireless headset.
Troubleshooting for tablet search mode and invalid card detection.
Details operating and storage conditions like temperature, humidity, and altitude.
Specifies voltage, frequency, current, and fuse rating for the system.
Technical details for IEEE802.11(b) and UHF wireless systems.
End-user license agreement for the device software.
Information on electromagnetic emissions compliance and environment.
Guidelines for testing compatibility with other devices in the operating room.
Details on electromagnetic immunity standards and environments.
Outlines the warranty coverage, limitations, and exclusions for the product.
Procedures for contacting Stryker for service and handling claims.
Contact information for Stryker Endoscopy distributors globally.
Instructions for installing the telephone upgrade for the Sidne™ console.
Details on connecting and operating the Valleylab Force FX™ ESU with Sidne™.
Step-by-step guide for installing the battery pack into the Sidne™ tablet.
Information on the optional battery charging station for the Sidne™ tablet.
Safety warnings and precautions related to connecting the ESU.
Instructions for installing the cover plate on the ESU for serial port access.
Detailed steps for connecting the Sidne™ system to the ESU.
Guide on securing the EDAM module to the ESU or cart.
Steps to install the Sidne™ ESU Driver 2.0 for ESU communication.
Tablet interface commands for controlling the Electrosurgical Unit (ESU).
Detailed list of tablet commands for ESU functions like Bipolar, Coag, and Cut.
Lists voice commands for controlling ESU functions.
Explains feedback messages from Sidne™ related to ESU operation.
Solutions for problems preventing Sidne™ from accessing the ESU.
Troubleshooting for specific Sidne™ messages indicating ESU communication issues.
Information on electromagnetic immunity compliance for the Sidne ESU EDAM.
Instructions for positioning and connecting the tablet recharging cradle.
Steps for charging the tablet and its battery using the cradle.
Safety and procedure for cleaning the tablet recharging cradle.
Information regarding maintenance requirements for the cradle.
Reference to the main manual for warranty and repair information of the cradle.
To Next Page
