24 EN
Setting Up the Headset
Note For more information on the microphone headset, consult
3000 Series Professional UHF Wireless Systems, the user
manual packaged with the headset.
Setting Up the Receiver
1. Attach the two provided antennae to the rear receiver panel.
2. Position the receiver on a stable surface near the Sidne™
console.
3. Connect the power cord.
• Connect one end to the power input jack on the rear receiver
panel.
• Connect the other end to the 16-volt power jack on the rear
Sidne™ console panel.
4. Connect the receiver cable.
• Connect one end to the unbalanced audio output jack on the
rear receiver panel.
• Connect the other end to one of the microphone headset jacks
on the front Sidne™ console panel.
5. Power on the receiver. (The receiver will only power on if the
Sidne™ console is powered on.)
• The LCD screen will read “WAIT”.
• The alert indicator will shine red until the transmitter is powered
on.
To Next Page
Loading...
