What to do if Stryker Sidne says "O. R. Lights Disconnected" or "Overhead Camera Disconnected"?
If the Stryker Medical Equipment displays a message saying "O. R. Lights Disconnected" or "Overhead Camera Disconnected", power off the device. Ensure that the device is properly connected to Sidne™. Power the device back on.
What to do if EDAM LED is flashing amber on Stryker Medical Equipment?
If the EDAM LED is flashing amber, it indicates that Sidne™ is not communicating properly with the Sidne™ device EDAM. Try the following steps: 1. Power off the EDAM. 2. Ensure Sidne™ is powered on. 3. Ensure that the Sidne™ interface cable is plugged into the EDAM. 4. Ensure that the Sidne™ interface cable is plugged into Sidne™. 5. Power on the EDAM.
What to do if EDAM LED is OFF on Stryker Sidne Medical Equipment?
If the EDAM LED is off, it means that the device is not communicating properly with the EDAM. To resolve this: 1. Power off the device. 2. Ensure that the device adapter cable is plugged into the EDAM. 3. Ensure that the device adapter cable is plugged into the Visum Power box control box. 4. Power on the device. 5. Ensure that the Visum wall panel controls do not show any error. If they do, then contact Technical Support.
General| Category | Medical Equipment |
|---|---|
| Manufacturer | Stryker |
| Model | Sidne |
| Compatibility | Stryker Navigation Software |
| Display | Integrated Touchscreen |
| Software | Stryker Navigation Software |
| Precision | Submillimetric |
To Next Page
