12 EN
17. DVI-I / XGA-1 Input: Connects to a surgical camera.
18. Equipotential Ground Terminal
19. Power On / Off Switch: Enables the system to power on when in
the “I” position; powers off the system when in the “O” position
20. Voltage Selector: Selects either 120 or 240 Volts.
21. AC-Power Supply Input
22. USB 2.0 Ports: Reserved for future use.
23. Firewire Ports: Reserved for future use.
24. USB 1.1 Port: Reserved for future use.
25. Ethernet Port: Reserved for future use.
The Tablet
The remote-control tablet provides manual controls for the Sidne™
system and any devices connected to the console. The tablet has an
interactive touch screen that displays the devices connected to the
Sidne™ system and provides a control menu for each device. When a
command is selected by touching the tablet screen, the tablet relays the
command to the Sidne™ console where it is routed to the appropriate
device.
The tablet can be powered by rechargeable batteries for up to two
continuous hours, allowing for wireless use, or by a power cord that
connects to the rear panel of the Sidne™ console.
Note The tablet batteries will recharge automatically when the
tablet power cord is connected to the Sidne™ console
(when on), but it is recommended that they be charged
using the cradle (see Cradle Addendum). Full charging
time is two hours.
The tablet features several controls, which are described in Figure 4.
To Next Page
Loading...
