116 EN
Figure 2: Inserting the tablet into the charging dock
2. Allow the battery to charge completely before removing it from
the cradle.
To charge a battery that has been disconnected from the tablet:
1. Insert the battery into the battery-charging dock as shown in
Figure 3 below. The Battery Charge LED on the cradle will flash
orange while the battery charges.
Figure 3: Inserting a battery into the battery-charging dock
2. Remove the battery when the Battery Charge LED on the cradle
shines green.
Electrical Ratings
100-240V~
50/60Hz
1A
To Next Page
Loading...
