Stryker Sidne - Sidne Feedback Messages

58 EN
Sidne™ Feedback Messages
Note When the pump displays an error message, it shuts itself
off. This will cause Sidne™ to say, “Arthroscopy pump
disconnected.”
Sidne™ Meaning
“Arthroscopy
pump...”
Added as a prefix to the below messages when the control is issued from the
tablet or pump front panel while not in the arthroscopy voice-command menu.
“Stopped” The pump was stopped by voice, tablet, or front-panel command.
“Activated” The pump was activated by voice, tablet, or front-panel command.
“Wash mode off” The wash mode was stopped by voice, tablet, or front-panel command.
“Wash mode
selected”
The wash mode was activated by voice, tablet, or front-panel command.
“Knee joint
selected”
Knee-joint preset settings were selected by voice, tablet, or front-panel
command.
“Shoulder joint
selected”
Shoulder-joint preset settings were selected by voice, tablet, or front-panel
command.
“Small joint
selected”
Small-joint preset settings were selected by voice, tablet, or front-panel
command.
“Tubing not
inserted”
The pump detects that the tubing is not inserted when the pump is turned on.
“Overpressure” The pump detects an overpressure condition.
1000400723a