Stryker Neptune 3 User Manual

0703-001-700 Rev-C EN
www.stryker.com 29
▪ See Section 17 Glossary for the definitions of a new,
valid, used, expired, and invalid manifold.
1. Insert a new (valid) manifold into the manifold
receptacle of the canister to be tested.
2. Fully rotate the manifold clockwise to lock the manifold
into the manifold receptacle.
3. Make sure all the inlet ports of the manifold are
closed.
4. Push the START SUCTION button (Figure 20).
Make sure suction starts. If not, see Section 13
Troubleshooting.
5. Adjust the suction control dial of the canister to be
tested to the maximum suction level.
6. Verify the actual suction value displayed on the control
screen (Figure 13) changes and reaches a suction
level of at least 494 mm-Hg. If not, see Section 13
Troubleshooting.
7. Repeat this procedure to test the other canister.
8. Discard the manifold used for testing purposes.
Evacuate Smoke
Insert manifold
Reset Volumes
20 L
0 mL
Settings
Start Suction
Set up system
Turn clockwise
Insert manifold
Turn clockwise
4 L
0 mL
4L Light
Empty 4L
Canister
Figure 19 – Set Up System Screen
Evacuate Smoke
Reset Volumes
20 L
0 mL
Settings
Start Suction
Suction OFF
4 L
0 mL
4L Light
Empty 4L
Canister
Suction Limit
100
0
used
Actual:
mm-Hg
mm-Hg
Suction Limit
0
0
used
Actual:
mm-Hg
mm-Hg
MAX
HIGH
MED
LOW
OFF
OFF
MAX
HIGH
LOW
MED
MED
Start Suction
Figure 20 – To Start and Adjust Fluid Suction
0000160552, Rev. C Effective Date: Nov 25, 2015 1:43:15 PM
Print Date: Nov 25, 2015 02:19:13 PM

Stryker Neptune 3 Specifications

General

Brand	Stryker
Model	Neptune 3
Category	Water Pump
Language	English