Need help?Do you have a question about the Stryker Visum 450 and is the answer not in the manual?
General| Brand | Stryker |
|---|---|
| Model | Visum 450 |
| Category | Medical Equipment |
| Language | English |
Safety guidelines for authorized personnel and general handling of equipment.
Critical safety warnings, including electrical and unpacking precautions.
Lists essential tools for installation and maintenance procedures.
Procedures and component identification for unpacking Halogen light systems.
Procedures and component identification for unpacking Visum LED light systems.
Instructions for unpacking boom assemblies.
Guides on routing power and control cables for lighting systems.
Steps for installing standard and extended horizontal arms for surgical lights.
Instructions for routing cables through conduits and system components.
Steps for attaching standard LED and Halogen light heads to spring arms.
Specific instructions for installing low ceiling light heads.
Details on connecting wall control, power supply, and light head components.
Procedures for setting up Visum LED systems via laptop connection and software.
Instructions for adjusting yoke width and height for proper monitor placement.
Procedures for balancing the monitor and adjusting center of gravity for stability.
Steps to adjust brake tension for securing the monitor's position.
Guides for installing FLEXiS shelves and their components.
Guidance on attaching GCX accessory tracks to down tubes.
Instructions for adjusting the vertical height of spring arms.
Steps to adjust friction brakes for suspension stability and prevent drift.
Details on adjusting mounting flange and stops for OSC400 boom arms.
Procedures for adjusting mechanical stops and pneumatic brakes for OSC600.
Guides for installing cable covers on light and flat panel suspensions.
Details on installing In-Light Cameras and handle assemblies for lights.
Procedures for installing camera components and testing.
Steps for installing legacy suspension systems.
Instructions for setting up and installing standard width yokes.
Procedures for final cleaning, providing spares, and system review.
Explanation of the electronic control system and its functions.
Detailed guide for troubleshooting power supply box issues.
Procedures for diagnosing and resolving CAN bus communication issues.
Guidance on identifying and addressing air leaks in the boom system.
Procedures for replacing nitrogen regulators and med gas plates.
Detailed instructions for replacing brake bladders in OSC400 booms.
Steps for removing and reattaching front/back plates, MFR, and extrusions.
Procedures for disassembling and replacing the motor unit.
Instructions for replacing shelves with brakes and brake buttons.
Comprehensive list of part numbers for repairs and replacements.
Contact details for Stryker Customer Service and website.
To Next Page
