POWER SOURCE (AC ADAPTOR ONLY)
The SB6057 is powered by an external AC-DC adaptor with an output of DC 12V 1A
.
POWER CONNECTION
1. Connect the cord of the power adaptor to the DC IN JACK (#24) at the back of the unit.
2. Plug the power adaptor into a household wall socket.
RADIO OPERATION
1. Tap the STANDBY BUTTON (#11) to turn on the unit. The STANDBY INDICATOR (#2)
will turn off.
2. If you repeatedly tap the FUNCTION
BUTTON (#12), you will step through the different
modes available:
Phono -> USB -> FM Radio -> AM Radio -> AUX -> Bluetooth
3. Tap the FUNCTION BUTTON (#12) repeatedly to select FM or AM radio. The FM/AM
INDICATOR (#8) will light in red (FM Radio) or Green (AM Radio).
4. Tune to the required station by turning the TUNING CONTROL (#9).
5. Adjust the VOLUME CONTROL (#1) to obtain the desired volume level.
6. When you wish to turn off the Radio, tap the STANDBY BUTTON (#11) to turn off the unit.
The STANDBY INDICATOR (#2) will light.
Hints for best reception:-
- AM : The receiver has a built-in AM bar antenna. If AM reception is weak, slightly
rotate or change the position of the unit will usually improve the AM reception.
- FM : The receiver has a built-in FM ANTENNA (#22) hanging at the rear cabinet. This
wire should be totally unraveled and extended for best reception.
1. VOLUME CONTROL
16. STOP
2. STANDBY INDICATOR 17. + 10
3. PHONO INDICATOR 18. REPEAT ONE/REPEAT ALL
4. USB INDICATOR 19. HEADPHONE JACK
5. DIAL SCALE 20. AUX IN JACK
6. BLUETOOTH INDICATOR 21. SPEAKERS
7. AUX INDICATOR 22. FM ANTENNA
8. FM/AM INDICATOR 23. RCA LINE OUT R/L JACKS
9. TUNING CONTROL 24. DC IN JACK
10. USB PORT 25. 45 RPM ADAPTOR
11. STANDBY BUTTON 26. TONEARM LIFT LEVER
12. FUNCTION BUTTON 27. AUTO STOP SWITCH
13. SKIP
BUTTON
28. SPEED SELECTOR
14. SKIP
BUTTON 29. TONEARM
15. PLAY/PAUSE BUTTON 30. PITCH ADJUST CONTROL
To Next Page
Loading...
Need help?
General
