enter standby mode, standby LED lights up.
REPEAT MODE
REPEAT 1
To repeat the current track, press the REPEAT button once, the repeat indicator will flash
in LED display. The track will continue to play until the repeat function is turned off.
REPEAT ALL
To repeat all the tracks, press the REPEAT button twice, the repeat indicator will be solid
on. All the tracks on the disc will be played repeatedly.
To Cancel Repeat Function: Press the REPEAT button until REPEAT indicator goes off
from LED display.
CD PROGRAM PLAY MODE
This function allows the CD tracks to be played in programmed sequence.
1. Load the CD Disc you wish to program.
2. In CD STOP mode, press the PROG/PAIR button once, the program indicator will light
and flash. LED display will briefly show program number “01” and then flash "00" to
prompt for input track number.
3. Press SKIP BACKWARD button or SKIP FORWARD button until the
desired track number is reached.
4. Press the PROG/PAIR button to store the selection. Program number will advance
to “02” which show briefly and then flash "00" to prompt for input of next track to be
programmed.
5. Repeat above steps 3 - 4 until you have entered all 20 tracks you want to program.
6. To play the stored sequence, press the PLAY/PAUSE button. The PROGRAM
indicator will light steadily.
7. After all memory tracks have been played, the CD will stop automatically.
NOTES:
1.) When 20 tracks of CD music have been programmed, LED display will show the first
programmed track number. If you keep programming the track, the first programmed
track will be erased.
2.) The Repeat function also applies to programmed track playback.
To repeat programmed tracks
1. During program play, pressing REPEAT button once will repeat the specifically
programmed tracks.
2. Press the REPEAT button again will repeat all the programmed tracks.
To Erase programmed track
1. Press the STOP
button to stop the CD playback.
2. Lift up the CD ACTIVATE COVER, all programmed track will be erased.
To Next Page
Loading...
Need help?
General
