Studer D21m - Page 60

D21m System
6-24 D21m Modules Date printed: 25.09.07
S1
EF ABCD
ON
Default Setting:
S1
1234
ON
Default Setting:
LEDs: SDI LOCK Indicates a valid SDI signal at the input.
HD Indicates a valid HD SDI signal at the input.
DIP Switches: S1
Switch Setting
1
OFF: Enable de-embedder (factory default)
2
OFF: Enable embedder (factory default)
3
OFF: SFC bypass (factory default)
4
reserved (must always be OFF)
S1
Switch Setting
A
OFF: De-embedder groups 1&2 (factory default)
ON: De-embedder groups 3&4
B
OFF: Embedder groups 1&2 (factory default)
ON: Embedder groups 3&4
C
ON: All audio data in SDI will be cleared
(factory default: OFF)
D
OFF: no delay (factory default)
ON: 40 ms delay on all 8 SDI in channels
E
OFF: transparent for channel status bit
ON: generate channel status bit (factory default)
F
OFF: NTSC 525 test pattern is generated if no SDI input signal is present
(factory default)
ON: NTSC 1080i60 test pattern if no SDI input signal is present