In order to make ad adequate maintenance of the appliance, the user, the maintenance man or the non-
specialized staff must firstly keep in mind the elementary safety rules quoted on paragraph n. 1
GENERAL INFORMATION. Then, it is also compulsory to not remove the safety devices and the
protections during the routine maintenance.
OTHERWISE, THE PRODUCING COMPANY DECLINES ANY RESPONSIBILITY FOR DAMAGES OR
ACCIDENTS RESULTING FROM THE FAILURE TO COMPLY WITH THE ABOVE-STATED
OBLIGATION.
Considered the previous rules, the cleaning of the cooled storage must be done daily, in order to
guarantee the best quality and the perfect sanitariness of the treated products. Use water and non-
abrasive cleansing agents. Wash and rinse using a cloth or a sponge.
N.B. NO SHARP OR ABRASIVE INSTRUMENTS, NO SOLVENTS OR DILUENTS
For a better air circulation, keep clean also the condensing unit (part 10) removing from its wings dust etc.
To reach the condensing unit, you must pull out the plug from the electrical socket, and unscrew the front
panel (part 14) paying attention on not putting in excessive traction the electrical connections. Use a
vacuum cleaner in order of not having a dispersion of dust. Do not scrape with sharp or abrasive
instruments.
At the end, reassemble the front panel closing the fixing screws.
The defrosting water goes inside a tank in the bottom of the blast chiller/freezer. In case of extraordinary
maintenance to the refrigerating system, it is possible to remove the back panel, and also the lateral panel
if necessary. Such operations can be made exclusively by refrigerator or authorized technicians, and only
after having pull out the plug from the electrical socket.
Clean up the gaskets with a soft towel and water only, do not use any aggressive and/or corrosive
additive.
8.4 Electric wire substitution
If the feeder cable is damaged, its replacement must be performed by the manufacturer care service or by
a qualified technician. In any case, make sure to unplug the device first
9. Troubleshooting
If there is an abnormal elevation of the internal temperature of the machine, you should check first if:
• the mains lead is securely plugged
• the power is not subject to variations of ± 10%
In case of malfunctioning and when these a.m. data are correct, you should call your supplier.
Give information on the type of machine and its serial number: these data are shown on the label of each
unit.
10. Correct disposal
Legislative decree n. 151 - 25/07/2005 (ROHS – RAEE)
Implementation of directives 2002/95/CE, 2002/96/CE and 2003/108/CE, concerning the reduction of the
use of hazardous substances in electronic and electrical devices, as well as waste disposal (G.U. 29-07-
2005 n.175 s.o. n.35)
Correct disposal of this product (waste electrical and electronic equipment) (Applicable in the European
Union and other European countries with separate collection systems)
This marking shown on the product or its literature, indicates that it should not be disposed with other
household wastes at the end of its working life.
To prevent possible harm to the environment or human health from uncontrolled waste disposal, please
separate this from other types of wastes and recycle it responsibly to promote the sustainable reuse of
material resources.
Household users should contact either the retailer where they purchased this
product, or their local government office, for details of where and how they can take this item for details of
where and how they can take this item for environmentally safe recycling.
To Next Page
Loading...
