Subaru 2000 Forester - Windshield Wiper and Washer Switches

FORESTER U.S.A. (E)
3-18
windshield or rear window.
D Grease, wax, insects or other material on the windshield or the
wiper blades results in jerky wiper operation and streaking on the
glass. If you cannot remove those streaks after operating the
washer or if the wiper operation is jerky, clean the outer surface of
the windshield or rear window and the wiper blades using a sponge
or soft cloth with a neutral detergent or mild-abrasive cleaner. After
cleaning, rinse the window glass and wiper blades with clean water.
The glass is clean if no beads form on the glass when you rinse with
water.
D If you cannot eliminate the streaking even after following this pro-
cedure, replace the wiper blades with new ones. Refer to the “Wiper
blade replacement” section (chapter 10) for replacement instruc-
tions.
J Windshield wiper and washer switches
B Windshield wipers
HB2019BB
To turn the wipers on, push the wiper control lever down.
: Intermittent
LO : Low speed
HI : High speed
To turn the wipers off, return the lever to the “OFF” position.